Search results
Results From The WOW.Com Content Network
[1] The Charrière is measured by the ''outer'' diameter, and is defined as 1 Fr = 1/3 mm, and thus 1 mm = 3 Fr; therefore the diameter of a round catheter in millimetres can be determined by dividing the French size by 3. [2] The French units roughly correspond to the outer circumference of the catheter (see table below).
However, the 3 + 1 ⁄ 2-inch (89 mm) 12-gauge shell, with its higher SAAMI pressure rating of 14,000 psi (97 MPa) compared to standard 2 + 3 ⁄ 4-inch (70 mm) and 3-inch (76 mm) 12-gauge shells with their lower pressure rating of 11,500 psi (79 MPa), began to approach the performance of the 3 + 1 ⁄ 2-inch (89 mm) 10-gauge shells with a ...
In digital photography, the image sensor format is the shape and size of the image sensor . The image sensor format of a digital camera determines the angle of view of a particular lens when used with a particular sensor. Because the image sensors in many digital cameras are smaller than the 24 mm × 36 mm image area of full-frame 35 mm cameras ...
1:80: 3.810 mm HOj scale. Very close to wargaming 20 mm figure scale (20 mm is actually 1:80.5). [10] 1:76.2: 4 mm: Model railways (00) UK model rail scale 4 mm scale (OO Scale, etc.). 1:76: 4.011 mm: Model railways (00) Military models. Military vehicles. Used with 4 mm to 1 foot models as well. 1:75: 4.064 mm Used by Heller for model ships ...
The optical format is approximately the diagonal length of the sensor multiplied by 3/2. The result is expressed in inches and is usually (but not always) rounded to a convenient fraction. For instance, a 6.4x4.8 mm sensor has a diagonal of 8.0 mm and therefore an optical format of 8.0*3/2 = 12 mm, which is expressed as inch in imperial units.
Because of the identity property of multiplication, multiplying any quantity (physical or not) by the dimensionless 1 does not change that quantity. [5] Once this and the conversion factor for seconds per hour have been multiplied by the original fraction to cancel out the units mile and hour, 10 miles per hour converts to 4.4704 metres per second.
A circular milis a unitof area, equal to the area of a circlewith a diameterof one mil(one thousandth of an inch or 0.0254 mm). It corresponds to approximately 5.067×10−4 mm2. It is a unit intended for referring to the area of a wire with a circular cross section.
For example, consider a 700c × 23 mm tire, which has a nominal cross-section of 23 mm. 700c wheels have a rim diameter of 622 mm. Hence the wheel diameter is (2 × 23 mm) + 622 mm = 668 mm which is equal to 26.3 inches (rounded to 1 decimal place). 26 inch mountain bicycle wheels have a rim diameter of 559 mm. This ignores factors that ...