Gamer.Site Web Search

Search results

1. Results From The WOW.Com Content Network

2. Sheet metal - Wikipedia

   en.wikipedia.org/wiki/Sheet_metal

   Sheet metal is metal formed into thin, flat pieces, usually by an industrial process. Thicknesses can vary significantly; extremely thin sheets are considered foil or leaf, and pieces thicker than 6 mm (0.25 in) are considered plate, such as plate steel, a class of structural steel . Sheet metal is available in flat pieces or coiled strips.

3. American wire gauge - Wikipedia

   en.wikipedia.org/wiki/American_wire_gauge

   American Wire Gauge ( AWG) is a logarithmic stepped standardized wire gauge system used since 1857, predominantly in North America, for the diameters of round, solid, nonferrous, electrically conducting wire. Dimensions of the wires are given in ASTM standard B 258. [1] The cross-sectional area of each gauge is an important factor for ...

4. Birmingham gauge - Wikipedia

   en.wikipedia.org/wiki/Birmingham_gauge

   The gauge starts at the lowest gauge number of 5Ø or 00000, corresponding to the largest size of 0.500 inches (12.7 mm), and runs to the highest gauge number of 36, corresponding to the smallest size of 0.004 inches (0.10 mm).

5. Sheet resistance - Wikipedia

   en.wikipedia.org/wiki/Sheet_resistance

   Sheet resistance is the resistance of a square piece of a thin material with contacts made to two opposite sides of the square. [ 1] It is usually a measurement of electrical resistance of thin films that are uniform in thickness. It is commonly used to characterize materials made by semiconductor doping, metal deposition, resistive paste ...

6. Wire gauge - Wikipedia

   en.wikipedia.org/wiki/Wire_gauge

   No. 7/0, the largest size, is 0.50 inches (500 mils or 12.7 mm) in diameter (250 000 circular mils in cross-sectional area), and the smallest, No. 50, is 0.001 inches (1 mil or 25.4 μm) in diameter (1 circular mil [cross-sectional area] or 0.7854 millionths of a square inch).

7. Sheet pan - Wikipedia

   en.wikipedia.org/wiki/Sheet_pan

   A half sheet pan is 18 in × 13 in (460 mm × 330 mm); [1] quarter sheets are 9 in × 13 in (230 mm × 330 mm). [1] The half sheet is approximately the same size as the largest mass-market baking sheets found in supermarkets, and the quarter sheet is a common size for rectangular, single-layer cakes (e.g., the size used for a regular-sized box ...