Search results
Results From The WOW.Com Content Network
UTQG ratings (top) and tire code (bottom) on sidewall of Continental ContiProContact tire. Uniform Tire Quality Grading, commonly abbreviated as UTQG, is a set of standards for passenger car tires that measures a tire's treadwear, temperature resistance and traction. The UTQG was created by the National Highway Traffic Safety Administration in ...
The load index on a passenger-car tire is a numerical code stipulating the maximum load (mass, or weight) each tire can carry. For load range "B" tires, ETRTO (ISO-Metric) standards specify the load index rating at an inflation pressure of 36 psi (250 kPa) (table below), while P-Metric standards measure the load capacity at an inflation ...
Cold inflation pressure is the inflation pressure of tires before a car is driven and the tires (tyres) warmed up. Recommended cold inflation pressure is displayed on the owner's manual and on the placard (or sticker) attached to the vehicle door edge, pillar, glovebox door or fuel filler flap. Most passenger cars are recommended to have a tire ...
Tire uniformity. Tire uniformity refers to the dynamic mechanical properties of pneumatic tires as strictly defined by a set of measurement standards and test conditions accepted by global tire and car makers. These standards include the parameters of radial force variation, lateral force variation, conicity, ply steer, radial run-out, lateral ...
Temperature: with both solid and pneumatic tires, rolling resistance has been found to decrease as temperature increases (within a range of temperatures: i.e. there is an upper limit to this effect) [59] [60] For a rise in temperature from 30 °C to 70 °C the rolling resistance decreased by 20-25%. [61]
A tire-pressure monitoring system ( TPMS) monitors the air pressure inside the pneumatic tires on vehicles. [ 1] A TPMS reports real-time tire-pressure information to the driver, using either a gauge, a pictogram display, or a simple low-pressure warning light. TPMS can be divided into two different types – direct (dTPMS) and indirect (iTPMS).
Tire maintenance. Inspection and maintenance of tires is about inspecting for wear and damage on tires so that adjustments or measures can be made to take better care of the tires so that they last longer, or to detect or predict if repairs or replacement of the tires becomes necessary. Tire maintenance for motor vehicles is based on several ...
The patient should remain in the ice bath until their body temperature falls to 102.2 degrees. Then, they can be transported to the hospital. Preparing for heat illness in a warming world