Search results
Results From The WOW.Com Content Network
6061 sheet in the T4 condition can be formed with limited ductility in the cold state. For deep draw and complex shapes, and for the avoidance of spring-back, an aluminium hot stamping process ( Hot Form Quench ) can be used, which forms a blank at a elevated temperature (~ 550 C) in a cooled die, leaving a part in W-temper condition before ...
In electrical and safety engineering, hazardous locations (HazLoc, pronounced haz·lōk) are places where fire or explosion hazards may exist. Sources of such hazards include gases, vapors, dust, fibers, and flyings, which are combustible or flammable. Electrical equipment installed in such locations can provide an ignition source, due to ...
Right before a wheel locks up, it will experience a rapid deceleration. If left unchecked, the wheel would stop much more quickly than any car could. It might take a car two to four seconds to stop from 60 mph (96.6 km/h) under ideal conditions, but a wheel that locks up could stop spinning in less than a second.
2024 aluminium alloy is an aluminium alloy, with copper as the primary alloying element. It is used in applications requiring high strength-to-weight ratio, as well as good fatigue resistance. It is weldable only through friction welding, and has average machinability. Due to poor corrosion resistance, it is often clad with aluminium or Al-1Zn ...
The engine temperature on modern cars is primarily controlled by a wax-pellet type of thermostat, a valve that opens once the engine has reached its optimum operating temperature. When the engine is cold, the thermostat is closed except for a small bypass flow so that the thermostat experiences changes to the coolant temperature as the engine ...
UN Regulation 37 covers motor vehicle filament lamps. These are categorized in three groups: those without general restriction that can be used in any application, those acceptable only for signalling lights (not for road illumination lamps), and those no longer allowable as light sources for new type approvals but still permitted for production as replacement parts.
A CAGE code is a unique identifier to label an entity (that is, a specific government agency or corporation at a specific site) that is a CDA, ODA, or MFR of the part defined by the drawing. One corporation can have many CAGE codes, as can one government, because each division, department, and site (campus) can have its own CAGE code.
These values depend solely on the type/application code given in the first part of the code and are so numerous as to be impossible to indicate here. Additional symbols are separated from the main code by the plus sign (+). The most common additional symbols are the impact and temperature codes for structural steels, category 1 - Sxxx.