Search results
Results From The WOW.Com Content Network
Has an ATmega328 with Arduino bootloader, a dual H-bridge and additional prototyping space and headers. It is compatible with many shields, though four digital pins are used when operating the motor controller. Has an onboard voltage regulator, additional LEDs, a temperature sensor, and a light sensor. Part of the DFRobotShop Rover kit ...
The temperature measuring system consists of a controller (laser source, pulse generator for OTDR or code generator for Code Correlation or modulator and HF mixer for OFDR, optical module, receiver and micro-processor unit) and a quartz glass fibre as line-shaped temperature sensor. The fibre optic cable (can be 70 km in length [5]) is passive ...
PIC (usually pronounced as /pɪk/) is a family of microcontrollers made by Microchip Technology, derived from the PIC1640 [ 1][ 2] originally developed by General Instrument 's Microelectronics Division. The name PIC initially referred to Peripheral Interface Controller, [ 3] and is currently expanded as Programmable Intelligent Computer. [ 4]
2.3 Service 03 - Show stored Diagnostic Trouble Codes (DTCs) 2.4 Service 04 - Clear Diagnostic Trouble Codes and stored values 2.5 Service 05 - Test results, oxygen sensor monitoring (non CAN only)
The silicon bandgap temperature sensor is an extremely common form of temperature sensor ( thermometer) used in electronic equipment. Its main advantage is that it can be included in a silicon integrated circuit at very low cost. The principle of the sensor is that the forward voltage of a silicon diode, which may be the base-emitter junction ...
The integrated circuit sensor may come in a variety of interfaces — analogue or digital; for digital, these could be Serial Peripheral Interface, SMBus/I 2 C or 1-Wire.. In OpenBSD, many of the I 2 C temperature sensors from the below list have been supported and are accessible through the generalised hardware sensors framework [3] since OpenBSD 3.9 (2006), [4] [5]: §6.1 which has also ...
Linear heat detection (LHD) cable is essentially a two-core cable terminated by an end-of-line resistor (resistance varies with application). The two cores are separated by a polymer plastic, that is designed to melt at a specific temperature (commonly 68 °C for building applications), and without which causes the two cores to short.
The Steinhart–Hart equation is a model relating the varying electrical resistance of a semiconductor to its varying temperatures. The equation is. where. T {\displaystyle T} is the temperature (in kelvins ), R {\displaystyle R} is the resistance at. T {\displaystyle T} (in ohms),