Search results
Results From The WOW.Com Content Network
In electrical and safety engineering, hazardous locations (HazLoc, pronounced haz·lōk) are places where fire or explosion hazards may exist. Sources of such hazards include gases, vapors, dust, fibers, and flyings, which are combustible or flammable. Electrical equipment installed in such locations can provide an ignition source, due to ...
Radiators are heat exchangers used for cooling internal combustion engines, mainly in automobiles but also in piston-engined aircraft, railway locomotives, motorcycles, stationary generating plants or any similar use of such an engine. Internal combustion engines are often cooled by circulating a liquid called engine coolant through the engine ...
ATEX Directive 2014/34/EU was published on 29 March 2014, by the European Parliament. It refers to the harmonization of the laws of the Member States relating to equipment and protective systems intended for use in potentially explosive atmospheres. Regarding ATEX 99/92/EC Directive, the requirement is that Employers must classify areas where ...
Volvo S40. Volvo V50. The Volvo V40 is a small family car ( C-segment in Europe) manufactured and marketed by Volvo Cars from 2012 to 2019. [ 1] It was unveiled at the 2012 Geneva Motor Show, and was on sale in Europe between 2012 and 2019. [ 4][ 5]
The DOT code [1] is an alphanumeric character sequence molded into the sidewall of the tire and allows the identification of the tire and its age. The code is mandated by the U.S. Department of Transportation [2] but is used worldwide. [3] The DOT code is also useful in identifying tires subject to product recall [4] or at end of life due to age.
Automatic transmission fluid (ATF) is a hydraulic fluid that is essential for the proper functioning of vehicles equipped with automatic transmissions. Usually, it is coloured red or green to differentiate it from motor oil and other fluids in the vehicle. This fluid is designed to meet the unique demands of an automatic transmission.
6061 sheet in the T4 condition can be formed with limited ductility in the cold state. For deep draw and complex shapes, and for the avoidance of spring-back, an aluminium hot stamping process ( Hot Form Quench ) can be used, which forms a blank at a elevated temperature (~ 550 C) in a cooled die, leaving a part in W-temper condition before ...
In the United States, entry 49 CFR 564 in the Code of Federal Regulations requires manufacturers of headlight bulbs, officially known as "replaceable light sources", to furnish the National Highway Traffic Safety Administration (NHTSA) with product specifications at least 60 days prior to first use. [6]